Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Cost in Pimlico?
Garage door work in Pimlico typically costs between $150 and $600, depending on what failed and how much of the system needs attention. A single broken spring usually runs $180 to $340, while a full new door installation lands between $700 and $2,200. Those are estimated ranges for this market; the written estimate we give you after looking at the door sets the final price.
We’re the multi-brand garage door specialist that works on the door and the opener together, so a spring job, a dead LiftMaster board or a full Clopay replacement all get handled by technicians trained on the equipment in front of them. Our technicians have up to 10 years of experience, and they diagnose by brand rather than by guesswork. Estimates are free. Call (877) 378-7082, and we’ll get a real number to you. We answer 24/7, with fast dispatch from 7am to 7pm.
Garage Door Cost Breakdown (2026)
Here’s what the common jobs run in Pimlico, priced per job by the estimate rather than by the hour. A matched pair of springs is usually replaced together, and that costs about twice the single-spring range below.
| Job | Typical estimated range |
|---|---|
| Garage door repair (general) | $150 – $600 |
| Spring repair (one spring) | $180 – $340 |
| Cable repair | $130 – $250 |
| Opener repair | $120 – $320 |
| Opener installation | $250 – $550 |
| Panel replacement | $250 – $500 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
| New door installation | $700 – $2,200 |
Three things move the number most: the brand and model of the part, how much of the system has to come apart to reach it, and whether a matched set is involved. A torsion spring job on a double door is a bigger piece of work than a single spring on a one-car door. Replacing an opener on a modern Wi-Fi unit from LiftMaster, Chamberlain or Genie takes brand-specific setup, not a universal swap. And a new door is quoted on the door, the hardware and the opener together, so those prices stretch from the low end for a basic single door to the top of the range for a wide, insulated double with a connected opener.
It helps to know the difference between a repair and a replacement before you compare numbers. Small jobs fall under garage door repair and stay in the lower half of the range; a failing door with cracked panels, worn tracks and a tired opener can climb toward the top.
What Affects Garage Door Pricing in Pimlico
The Pimlico market has its own habits, and they show up in the estimate. These are the factors that push a price up or keep it down.
- Which part failed. A roller is the cheapest fix on the list at $110 to $220. A spring is the most common and lands at $180 to $340 for one. The wider the problem spread, the higher up the $150 to $600 repair range you go.
- Brand-specific parts. We work on the brand you already have, whether that’s a Clopay door, an Amarr panel or a Raynor opener. A matched part that fits the existing hardware is usually cheaper than adapting a generic one, and it lasts longer.
- Door size and door count. A single-car door takes less material and less labor than a double. That gap shows up most on panel replacement, where $250 to $500 covers one panel on an average door but climbs on a wide insulated one.
- Age and condition of the rest of the system. A door that’s been out of balance for a while wears rollers and cables faster. Fixing one part on a door that needs three usually costs more than the single line item suggests.
- Inside vs. outside the track. A misaligned track that can be straightened stays near $120 to $240. A track that’s bent behind the wall or tied into damaged framing needs more work before the door runs right again.
- Emergency timing. A door stuck open overnight is a security problem, so we treat emergency work as a core service, not an add-on. We answer the phone 24/7 so we can book the first available slot, with fast dispatch from 7am to 7pm.
If you’re in the middle of this and not sure what failed, the fastest path is a call. We’ll tell you what we need to see and what to do with the door while you wait.
How to Save on Garage Door
The biggest savings come from catching a problem before it spreads. A worn roller that gets replaced at $110 to $220 is cheaper than the cable and track damage it causes when it finally lets go. A door that groans, jerks or reverses on its own is telling you something is wearing.
Keep the door balanced. A properly balanced door lifts with one hand and stays put halfway up. When it doesn’t, the spring is usually the culprit, and getting to it early keeps you near the $180 to $340 range instead of replacing a spring, a cable and a set of rollers at once.
Don’t overpay for parts that don’t fit. Brand-specific diagnostic work means we identify the right part the first time. That’s why we work across eight widely installed brands – LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman and Raynor – rather than forcing one brand onto your door. It also means your opener board gets read for what it is, not swapped out because someone guessed.
Get the estimate in writing before any work starts. That’s how you know what you’re paying and why. Our estimates are free, and the written estimate sets the price. Call (877) 378-7082 for a quote on the Pimlico door in front of you. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
When a Repair Is the Smarter Call Than a New Door
Most failed doors don’t need replacing. A spring, a cable, a set of rollers or a bad opener board is a repair, and those stay in the $110 to $340 zone. The math flips toward a new door when the panels are cracked or dented across several sections, the tracks are bent past straightening, or the door and opener are both failing at once. In those cases the $700 to $2,200 installation range often comes in close to the cost of stacking three or four repairs.
We treat spring repair as a specialty rather than a commodity task. That high-tension work is where a lot of general repair services stop and outsource, and it’s where a trained hand matters most. If you’re weighing a repair against a replacement, call and we’ll walk you through which way the estimate goes for your door.
Safety: When Not to Touch the Door Yourself
Torsion spring repair is genuinely dangerous work. The springs, cables and brackets that hold a garage door up are under heavy tension even when the door is closed, and they can release suddenly with enough force to cause serious injury. The same goes for the opener’s wiring and any electrical connections behind the control panel. Those are jobs for a trained technician with the right tools, not a weekend project.
If a spring has snapped, a cable has come loose, or the door is hanging crooked, leave it closed and call. Don’t try to lift the door by hand to free a car or to force it open. If you need help with a door that has already failed, we can get a technician out for a proper look. Call (877) 378-7082. We answer 24/7. Fast dispatch from 7am to 7pm.
What We Work On
We cover both sides of the system: the door itself (installation, panel replacement, repair) and the opener that runs it. Opener work covers the dominant smart-home brands – LiftMaster, Chamberlain, Genie and Craftsman – including legacy units and modern Wi-Fi and app-connected openers. If your opener is beeping, flashing a code, or refusing to close, that’s an opener repair at $120 to $320 or an opener installation at $250 to $550 to replace a unit that’s beyond saving.
Our technicians have up to 10 years of experience across those brands, and they read the failure by the system it belongs to, not by whatever part is closest to hand.
FAQs – Garage Door Cost
How much does garage door repair cost in Pimlico?
Garage door repair in Pimlico typically runs $150 to $600, depending on which part failed and how much of the system is affected. A single spring runs $180 to $340, a cable $130 to $250 and a track realignment $120 to $240. Call (877) 378-7082 for an exact quote – estimates are free.
How much does a new garage door cost in Pimlico?
A new door installation runs $700 to $2,200 for a typical residential door. That range covers the door, the hardware and the labor; a wide insulated double door with a connected opener sits near the top, a basic single door near the bottom. Call (877) 378-7082 with your door size and we’ll get a written estimate to you.
Is it cheaper to repair or replace a garage door?
Repairing is almost always cheaper, usually $110 to $340 for a single worn or broken part versus $700 to $2,200 for a new door. Replacement makes sense when the panels are cracked across several sections, the tracks are bent past repair, or the door and opener are both failing at the same time. Call (877) 378-7082 and we’ll tell you which way the numbers fall for your door.
Can you fix a garage door the same day?
Most repairs can be handled the same day when the parts are on hand for that brand, and a spring repair is usually done in a single visit. We answer 24/7 and book the first opening, with fast dispatch from 7am to 7pm, Sunday through Friday. Call (877) 378-7082 with the brand and model so we can come prepared.
Why does my garage door estimate vary so much?
Estimates vary because the parts, the door size and the brand change the job. A single-car door needs less material than a double, a matched pair of springs costs about twice a single spring, and a brand-specific opener board can cost more than a generic roller set. The written estimate sets the final price. Call (877) 378-7082 for yours.
Pricing reflects the Pimlico market as of 2026. Garage Door Repair Govans offers free estimates – call (877) 378-7082.
What Our Customers Say
"Both cables had come off the drum and the door was hanging crooked. I'd watched a video and was about ten minutes from trying it myself, which the tech told me would have been a genuinely bad idea. Glad I called."
- Tamika Whitfield"Track was bent and two of the rollers were shot. He straightened what he could, swapped the rollers for nylon ones, lubricated everything, and had it done in about an hour."
- Alicia Grant"Opener kept reversing halfway down. Turned out to be the safety sensors knocked out of alignment by a bicycle. He straightened them, wouldn't charge me for it, and just asked me to keep them in mind if I need real work later."
- Tim Lawson